ATTACHING THE NECK TO THE BODY.
1. Put a 1/8" drill bit into the drill with the exposed part of the bit the same length as a neck plate screw.
2. Gently slot the heel of the neck into the neck pocket of the body.
3. Holding the neck snugly into the body pre-drill the four 1/8" holes into the heel of the neck.
(BEFORE DRILLING - make sure the length of the drill bit showing does not exceed the length of a neck plate screw.)
4. Lay the body and neck face down on a flat surface and place the neck plate in position.
5. Insert the four neck plate screws to secure the neck in position but do not fully tighten them just yet.